Generating an Automated Contact Report

Once the simulation submitted via the MotionView Run panel is completed, follow the steps below:
  1. From the Analysis menu, click View Reports.


    Figure 1.
    The View Reports dialog is displayed.


    Figure 2. The report item (Contact Report for the last submitted run) will be listed at the top.
  2. Select the item and click OK.
    The following pages with results, described in earlier sections, are added to the report. Use the Previous Page/Next Page icons buttons (located at the upper right corner of the window, below the menu bar area and above the graphics area), to view these pages:
    • Contact Force Animation - Contact Region Output
    • Contact Overview
    • Penetration Depth Animation
    • Contact Force Plots