*EndStudy()

Specifies the end of the study block.

Syntax

*EndStudy()

Application

HyperView

Example

*BeginFLD()
     *BeginStudy("Study 1", "On")
           *BeginFLC()
                 *Engineering("On")
                 *CurveSource("Math", "0.20 1.00")
           *EndFLC()
           *BeginSelection(Part, SelectVisible)
                *Add("all")
           *EndSelection()
           *ResultType("Strain")
           *Layer("Lower")
           *LegendType("Zone")
           *Compression("UseAngle", 45, "On")
           *Margin(10, "On")
           *LooseMetal(2, "On")
           *FitCurve("On")
     *EndStudy()
*EndFLD()

Comments

This marks the end of the study block.