Post Processing
Utilize GeoD-Post to post process simulation results.
Utilize various capabilities of GeoD Post to post process simulation results in numerous intuitive and impactful ways. The specific GeoD-Post capabilities in this release are focused on mechanical simulations and geo-mechanical investigations such as fault and fracture stability.
The Post-processing module uses the functionalities of HyperView to post
process simulation results. This module allows you to perform the following
operations:
- Read and convert stress results into geological conventions using the Abaqus parameter naming scheme;
- Auto-generate geologically useful parameters not directly available from FEA results;
- Map parameters from one discretization (mesh) to another of the same or lower geometric order;
- Dedicated 1D (well) plotting tool for direct analysis of result QA/QC and interpretation;
- Exporting results data into various formats.
The steps in the Post-Processing section are illustrated in the following image:
Figure 1. Launching GeoD Post
Launching GeoD Post on HyperView
Below are the steps to launch GeoD Post -
- Launch HyperView 2021.1 from HyperWorks installation location.
- Select .
GeoD Post will be activated in the GeoD Post Tab.
GeoD Post User Interface
User interface of GeoD Post to perform various post processing activities.
Once the GeoD Post tab is activated, the tab contains the following options -
- Convert result names to Abaqus convention
- Check the Convert result names to Abaqus convention button to activate the Launch Conversion tool
- Select GeoD Tool
- Stress Manipulation