Altair SimSolid Cloud 2024 Release Notes

Solver Update

Issues related to creation, copying, and updating boundary conditions specifically to bolt tightening.
Issues related to contact conditions at bolts.
Issues with respect to hydrostatic pressure units.
Issues related to display for copied design studies.
Issues updating datum points and pick point info when switching between analyses.
Issues related to viewing results, renaming and/or deleting datum point sets.
Issues with show disconnected group of parts when model has disable contacts.
Issues with rigid part mass value shown in edit mode.
Issues with locking the legend in post processing.
Improved display issues with respect to boundary conditions representation.
Improved display issues with selection of parts and reviewing results.
Improved display issues when creating connections, especially spot welds.
Issues related to the effect of boundary condition showing up after deleting in results.
Issues related to name of custom contact conditions when creating a new design study.
Issues related to number of analysis per project.
Issues related to bearing load angle and load span angle value greater than acceptable limit.
Issues related to part names not shown when editing any boundary conditions.
Issues related to solution settings, especially custom solution settings.
Issues with respect to updating values when units are changed from SI to IPS.
Issue related to consistency of name in boundary condition list and in the dialog.