モデルの作成
CADFEKOでモデルを作成します。このモデルに必要なポートと給電源をすべて定義します。このモデルの動作周波数または動作周波数範囲を指定します。
-
誘電体媒質を作成します。
- Label: RogersDuroid5870
- Relative permittivity: 2.2
- Dielectric loss tangent: 0.0012
-
底面に導電層を設けた平面積層基板(無限平面)を追加します。
-
Plane / ground.を選択します。
- Planar multilayer substrateをクリックします。
- Thickness (Layer 1): 2.5e-3
- Medium (Layer 1): RogersDuroid5870
- Ground plane (Layer 1): PEC
- Z value at the top of layer 1:0
-
Plane / ground.を選択します。
-
パッチを作成します。
-
長方形を作成します。
- Definition method: Base centre, width, depth
- Base centre (C): (0, 0, 0)
- Width (W): 39e-3
- Depth (D): 39e-3
-
長方形を作成します。
-
インセット給電を作成します。
-
長方形を作成します。
- Definition method: Base corner, width, depth
- Base centre (C): (-1.4e-3, -39e-3/2, 0)
- Width (W): 2.8e-3
- Depth (D): 6.5e-3
- Label: InsetRectangleLarge
-
別の長方形を作成します。
- Definition method: Base corner, width, depth
- Base centre (C): (-1.4e-3/2, -39e-3/2, 0)
- Width (W): 1.4e-3
- Depth (D): 6.5e-3
- Label: InsetRectangleSmall
- InsetRectangleSmallをInsetRectangleLargeに結合します。
- この結合をコピーして90°回転します。
- ツリーにあるすべてのパートを結合します。
- 新たに作成したUnion1から2つのフェイスペアを削除し、インセット給電の作成を完了します。
-
長方形を作成します。
- インセット給電の外側エッジ上で、給電ごとに1つ、合計2つのマイクロストリップポートを作成します。
-
新しいネットワークを作成します。
- Data type: S-matrix
- Source: Touchstone file
- Number of network terminals: 3
- .s3pファイルを探して選択します。
- 概略図ビューで、ネットワークの出力ポートにパッチの入力ポートを接続します。
-
GeneralNetwork1.Port1に電圧源を追加します。
Note: この電圧源は概略図ビューに表示されません。
-
周波数を設定します。
- Continuous (interpolated) range
- Start frequency (Hz): 0.8*2.4e9
- End frequency (Hz): 1.2*2.4e9
Note: 出力要求は不要です。この電圧源の入力インピーダンスは自動的に計算されます。