Energy equation in nanoFluidX is implemented so that it accommodates
for conduction and convection heat transfer with initial or Dirichlet boundary
conditions.
The rate of temperature change of a specific material is given by:
(1)
With
being time,
being the temperature,
the coefficient of thermal conductivity,
the density and
the specific heat capacity of the
material. In SPH form the above analytic expression becomes
(2)
Where, the indices
and
standing for so called ‘owner’ and ‘neighboring’
particles respectively, and the
index is a difference between the respective
variables of particle
and particle
. The
stands for mass of the particle, the
is the gradient of the kernel,
is the position vector and
is the unit coordinate vector.
If you want to use the energy transport option, you need to turn the feature ON by
setting the energy_transport flag in Simulation parameters to
true. Once this step is completed, you can opt for desired output, which can be
either temperature or rate of temperature change (flux). The code will not work if
an output is required and the energy transport flag is turned off.
Finally, set up the phase parameters, which are initial temperature
(
temp_0) in [K], evolve temperature flag
(
evolve_temp), specific heat capacity of the material
(
heat_cap) in [J/kg/K] and heat conduction coefficient of the
material (
heat_cond) in [W/m/K].
Note: Regarding the
evolve_temp flag, this parameter is valid only for
WALL or MOVINGWALL phases. If the
evolve_temp flag is set to false, or if it is not defined
(default is false), the set initial temperature will remain constant throughout
the simulation. If set to true, the initial temperature will evolve in time and
the temperature of the WALL or MOVINGWALL will
be influenced by any surrounding phase. For FLUID phases, the
temperature always evolves.