Observation Directions

When selecting this option (remember that it’s only active when the type of the simulation is Far Field), the following panel will appear:



Figure 1. Observation directions panel

In this panel, we can specify the observation directions:

  • Sweep angle
    • the type of cut (phi cut or theta cut)
  • Cut:
    • Number of cuts: describes the number of cuts. It is an integer value.
    • Initial cut: defines the angular initial value (in degrees) of the cuts.
    • Final cut: defines the angular final value (in degrees) of the cuts.
  • Number of points
    • Number of points: describes the number of points. It is an integer value.
    • Initial point: defines the angular initial value (in degrees) of the points.
    • Final point: defines the angular final value (in degrees) of the points.