Resolved Issues

The following is a list of issues that were resolved in 2019.

Resolved Issues 2019.4

Fixed an issue where the Measure tool failed to show the curvilinear length and radius for circular edges.
Fixed an issue where callouts were not being created correctly.
Tryout: Fixed an issue with positioning of the pad relative to the attached tool in closed position for multi-stage operation analysis.
Tryout: Force plots have been corrected to show the force in the forming direction rather than the resultant force.
Tryout: Fixed an issue with positioning of tools based on the operation setting rather than the individual tools setting in multi-stage operations.
Tryout: Fixed an issue where the pin position was not updated based on changes to its diameter.
Tryout: Fixed an issue with thinning results when running a tryout analysis with a fine mesh smaller than 2 mm.
Tryout: Fixed an issue where tailor welded blanks were treated as an independent piece during the run.
Tryout: Fixed an issue that caused run failures for multi-stage operations when a point or vertex on a blank shares more than one symmetry plane.
Tryout: Fixed an issue that caused piercing to fail when the pierce line was outside of the blank.
Feasibility: Fixed an issue where the surface failed to mesh and was missing results.
Feasibility: Fixed an issue that caused run failures due to foreign language characters in the run name.
Feasibility: Fixed an issue creating and loading flat blanks after feasibility analysis.

Trimming with open trim lines improved to identify removable areas in the blank.
Blank Nesting improved to support flat blanks as part.
Runs at Model Location appear in the Run History even if file and run names are different.
Warning message provided before multiple parts are designated to a single tool.
Die Compensation works for custom forming operations.
Multistage stamping now works even if the symmetry plane location on the blank were trimmed.
Multiple line selection for draw beads fixed so that a draw bead is created for each continuous line.

Modifying the CAM tool direction using the manipulator is corrected to align with the draw direction.
Pin creation on the sheet edge is improved to handle arbitrary edge selection.
Feasibility run failures due to sliver-like elements and elements of negative volume are fixed.

When you close the application, the analysis will continue to run. Once the run has completed, the results will be available in the run history.
Improved performance when loading results for large models while post-processing individual operations or reviewing stages of a multistage operation.